Line locking machine to send the book post is not in place fault cause analysis
1, the upper send book post wheel down time is not accurate. In accordance with the "instruction manual" to adjust the downward pressure time.
2, the locking machine up and down to send the book post wheel gap is too large, resulting in the locking machine up to send the book post wheel and the friction between the lower send the book post wheel is small, due to the material or thickness of the book post, the friction required is not the same. Wear and tear of the upper feeder wheel will also reduce the friction. Loosen the lock nut counterclockwise and adjust the bolt clockwise to increase the friction of the feeder wheel enough to accurately convey the booklet to the table stopper. Then lock the nut.
3, when the platform and send a book post tripod into a straight line, the front edge of the book post being transported (rule side) should be more than send the vertical center line of the post wheel 50mm.
4, the position of the posting chain is not correct, the locking machine is too late to push the book posting, the position of the posting chain should be adjusted in accordance with the "User Manual".
5, send book post wheel speed is low. Adjust the speed of the accelerator wheel clockwise in the operation panel until each post can be accurately in place.
